NVP vProxy: How to manually change the vProxy Appliance network interface settings

The process for changing vProxy network information is outlined in the NetWorker VMware Integration Guide, available through: https://www.dell.com/support/home/product-support/product/networker/docs (You must be signed in with your Dell support account).

1. Open an SSH session to the vProxy appliance and authenticate with the admin account.

2. Switch users to root:

sudo su -

3. Run the config_network.sh script to update the interface settings replacing the parameters with your host/network info: 

/opt/emc/vproxy/bin/config_network.sh <Interface> <FQDN> <IP Address> <Netmask> <Gateway> <DNS List (comma separated)>

Example:

nsr-vproxy01:~ # /opt/emc/vproxy/bin/config_network.sh eth0 nsr-vproxy01.amer.lan 192.168.9.151 255.255.255.0 192.168.9.1 192.168.9.100
Successfully applied new network settings
active
Restarting network services...
eth0            up
      link:     #2, state up, mtu 1500
      type:     ethernet, hwaddr 00:50:56:be:35:0c
      config:   compat:suse:/etc/sysconfig/network/ifcfg-eth0
      leases:   ipv4 static granted
      addr:     ipv4 192.168.9.151/24 [static]
      route:    ipv4 default via 192.168.9.1 proto boot
Restarting vProxy services...

nsr-vproxy01:~ # cat /etc/sysconfig/network/ifcfg-eth0
DEVICE=eth0
BOOTPROTO='static'
STARTMODE='auto'
USERCONTROL='no'
IPADDR=192.168.9.151
NETMASK=255.255.255.0

nsr-vproxy01:~ # cat /etc/resolv.conf
search amer.lan
nameserver 192.168.9.100
nsr-vproxy01:~ #

4. Reboot the vProxy Appliance:

reboot

• NVP vProxy: config_network.sh fails to configure a network interface stating that the script must be run with superuser privileges.
• NVP vProxy: How to Change the Time Zone of the vProxy Appliance
• NVP-vProxy: How to update or change vProxy admin or root password