PowerScale Isilon: PowerScale Node Boots to an OK Prompt

요약: The node boots to an OK prompt when powering up or rebooting a node with a null modem cable attached to a personal computer or serial concentrator.

이 문서는 다음에 적용됩니다. 이 문서는 다음에 적용되지 않습니다. 이 문서는 특정 제품과 관련이 없습니다. 모든 제품 버전이 이 문서에 나와 있는 것은 아닙니다.
기타 리소스 확인

증상

The boot sequence ends at an OK> prompt similar to below when powering up or rebooting an Isilon PowerScale node:
Example of the OK prompt

원인

During the boot sequence, when the boot loader is running, characters sent to the terminal session interrupt the boot session. In addition to trying to type during the boot sequence, if:
  • A keep alive application running on the machine you are connected with to keep the computer from going to sleep
  • A damaged serial adapter on the computer that you are using for a console
  • A damaged null modem cable, serial cable, or null modem adapter
  • On a serial concentrator switch, a damaged or broken switch port
Note: If you are serial attached to a PowerScale node built on Gen16 PowerEdge technology (F210, F710, F910), in addition to the boot sequence, updating the CPLD firmware while serial attached, show an OK prompt. This is expected, and the node reboots itself after the update completes (approximately 15 minutes). Do NOT perform the resolution to resolve this as any keystrokes cause the upgrade to fail.

해결

To continue the boot sequence, type boot then press enter. The boot loader continues running from the point that it was interrupted at. Type reboot then press enter, the node begins the boot process all over again. Any keystroke entries during the reboot can trigger the boot loader interruption again.

해당 제품

Isilon, PowerScale
문서 속성
문서 번호: 000227664
문서 유형: Solution
마지막 수정 시간: 14 8월 2024
버전:  1
다른 Dell 사용자에게 질문에 대한 답변 찾기
지원 서비스
디바이스에 지원 서비스가 적용되는지 확인하십시오.