Dell Command | Power Manager Version 2.0 User Guide

Enabling Advanced Charge

1. Click the Advanced Charge tab in the left pane.
   NOTE: Hover your cursor over the icon if you later want to see further information on Advanced Charge.
2. To enable Advanced Charge, click the toggle at the top of the page to the On position.
3. Click the toggle for each day of the week to enable or disable Advanced Charge for each day.
   If you enable the Advanced Charge feature, you must configure the feature for at least one day.
4. To set the times of day when Advanced Charge is active and inactive, click Settings.
   NOTE: If you have not enabled Advanced Charge for a particular day, that day will not display on the Time Settings page, and you will not be able to set the Advanced Charge schedule for that day. Go back to the main Advanced Charge page and enable Advanced Charge for that particular day.
5. In the Time Settings screen, click a day of the week. In the main portion of the page, you can use either the circular slider or the drop-down menus to set the time.
   NOTE: You can select times in 15-minute increments—for example, you can enter 11:15 AM or 9:30 PM.
   The circular slider represents a 24-hour period. To use the circular slider:
   1. Slide the Start of day thumb control to the start time of a typical workday.
   2. Slide the End of day thumb control to the end time of a typical workday.
      NOTE: The segment of time displayed in blue represents the work period, or when the system is active.
   Alternatively, you can use the drop-down menus to set the times:
   1. Select a time for Start of day.
   2. Select a time for End of day.
6. Select the Copy the same settings to multiple days check box. In the left pane, select the days to which these settings apply.
7. Click OK to save your settings, or click CANCEL to discard them.