In this configuration,
the uplink ports from the embedded network switch on a sled and the
four uplink ports on the enclosure pass-through modules (PTM) to which
the sled maps are configured in a single trunk group or Link Aggregation
(LAG). The ports on the external switches to which the enclosure pass-through
modules connect must be configured into a single trunk configuration
or LAG. Alternatively, spanning tree must be run on the external rack
switches to disable three of the four uplink ports.Figure 1. Standard configuration
Table 1. Standard configuration
icon descriptionThe following table describes about the standard
configuration icons.
Icon
Description
Network path
Single trunk configuration or LAG
Static LAG
NOTE: The image
shows two external rack switches. However, the standard configuration
also supports uplinks of all four ports to a single external rack
switch.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
