- Notes, cautions, and warnings
- About your system
- Performing initial system configuration
- Pre-operating system management applications
- Navigation keys
- About system setup
- Entering System Setup
- System Setup main screen
- System BIOS screen
- System Information screen
- Memory Settings screen
- Processor Settings screen
- SATA Settings screen
- Boot Settings screen
- Integrated Devices screen
- Serial Communications screen
- System Profile Settings screen
- System Security screen
- Miscellaneous Settings screen
- About Boot Manager
- About Dell Lifecycle Controller
- Changing the boot order
- Choosing the system boot mode
- Assigning a system or setup password
- Using your system password to secure your system
- Deleting or changing an existing system and/or setup password
- Operating with a setup password enabled
- Embedded system management
- iDRAC Settings utility
- Processor core licensing
- Networking configurations
- Installing sled components
- Recommended tools
- Removing the sled
- Installing the sled
- Inside the sled
- Cable cover
- Cooling shroud
- System memory
- Hard drives/SSDs
- Hard drive/SSD to node assignment
- Removing a hard drive/SSD
- Installing a hard drive/SSD
- Shutdown procedure for servicing a hard drive/SSD
- Configuring the boot drive
- Removing a 2.5 inch hard drive/SSD from a hard-drive/SSD carrier
- Installing a 2.5 inch hard drive/SSD in a hard-drive/SSD carrier
- Removing a 1.8 inch SSD from the SSD carrier
- Installing a 1.8 inch SSD in the SSD carrier
- Hard-drive/SSD backplane
- SSD cage assembly
- Easy restore module
- System battery
- System board
- Control panel
- Troubleshooting your system
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- Getting help
Dell PowerEdge FM120x4 Owner's Manual
Installing the cable cover
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
- Align the tabs on the cable cover with the slots on the
cooling shroud.
NOTE: Ensure that the cables are routed properly on the cooling shroud before installing the cable cover.
- Lower the cable cover on to the cooling shroud until the tabs on the cable cover engage with the slots on the shroud.
- Slide the cable cover toward the front of the sled, until it engages with the release latch on the cooling shroud and is firmly seated.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\