Installing system
board
Steps
- Align the system board with the screw holders on the computer.
- Tighten the M2*2 screws to
secure the system board to the computer.
- Place the metal bracket to secure the DisplayPort
over USB Type-C.
- Tighten the M2*2 screws to secure
the metal bracket on the DisplayPort over USB Type-C.
- Connect the power connector port cable to
the connector on the system board.
- Connect the display cables to the connectors
on the system board.
- Place the metal bracket to secure the display
cable.
- Tighten the M2*2 screw to secure
the metal bracket.
- Connect the following cables:
- touchpad
- USH board
- LED board
- Install the:
- chassis frame
- system fan
- heat sink
- coin cell battery
- memory module
- SSD card
- WLAN card
- WWAN card(optional)
- hard drive assembly(optional)
- keyboard
- keyboard trim
- battery
- base cover
- SIM card
- Follow the procedure in After working inside
your computer.
Data is not available for the Topic