Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC630 Owner's Manual

PDF

Installing a PERC H730P slim card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  1. If installed, remove the PERC H730P slim card blank.
  2. Press the release latch on the side of the chassis to the unlock position.
    NOTE: Ensure that all the memory module ejectors are in the closed position.
  3. Align the slots on the PERC H730P slim card with the standoffs on the side of the chassis.
  4. Lower the PERC H730P slim card into the chassis until the slots on the card engage with the standoffs on the side of the chassis.
  5. Press the release latch to the lock position to secure the card firmly on the chassis.
    The PERC H730P slim card connects to the backplane connector.
  6. Hold the pull tag on the PERC H730 slim-card cable connector and route the cable between the memory-module ejectors.
  7. Align the retention screws on the PERC H730P slim-card cable connector with the screw holes on the system board connector.
  8. Tighten the two retention screws to secure the PERC H730P slim-card cable connector on the system board.
    Figure 1. Installing a PERC H730P slim card
    This image shows Installing a PERC H730P slim card
    1. PERC H730P slim card
    2. PERC H730P release latch
    3. lock and unlock icon on the PERC H730P slim card bracket

Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\