You must configure
the initial network settings based on your network infrastructure
to enable the communication to and from iDRAC. You can set up the
IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings utility
See Dell Integrated Dell Remote Access Controller
User's Guide at Dell.com/idracmanuals
Dell Deployment Toolkit
See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
Dell Lifecycle Controller
See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
CMC Web interface
See Dell Chassis Management Controller Firmware
User’s Guide at Dell.com/esmmanuals
You must use the default iDRAC IP address 192.168.0.120
to configure the initial network settings, including setting up DHCP
or a static IP for iDRAC.
NOTE: To access iDRAC, ensure that
you install the iDRAC port card or connect the network cable to the
Ethernet connector 1 on the system board.
NOTE: Ensure that you change
the default user name and password after setting up the iDRAC IP address.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\