Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerVault MD3060e Storage Enclosure Owner's Manual

PDF

Removing A Power Supply Module

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: The system requires one power supply module for normal operation. Remove and replace only one power supply at a time in a system that is powered on.
  1. Identify and locate the faulty power supply module.
    • NOTE: The Service action required indicator lights amber when there is a fault in the power supply module.
  2. Disconnect the power cable from the power source and the power supply module you intend to remove and remove the cables from the cable securing strap.
  3. Pull and rotate the two release levers away from the chassis until the power supply module is free from the slot.
  4. Hold the power supply module and slide the power supply out of the chassis.
    Figure 1. Removing and Installing the power supply module The figure shows removing and installing a power supply module.
    1. power supply
    2. release latch (2)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\