Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell Wyse ThinOS Version 8.6 Administrator’s Guide

PDF

Configuring PCoIP connections using Teradici Remote Workstation card

In ThinOS 8.6, you can directly configure the PCoIP connection using either the TERA2240 Remote Workstation Card or TERA2220 Remote Workstation Card. This feature is supported only on PCoIP-enabled thin clients. This feature only works with the direct PCoIP connection, and does not work when you connect using the Horizon View broker.
Prerequisites
  • Ensure that the Teradici Remote Workstation card version matches the Teradici PCoIP SDK version 2.9.
  • Ensure that host cards are connected to a remote workstation.
  • Ensure that host cards are installed correctly, that is, connected to a remote workstation with GPU.
NOTE: The SDK in ThinOS does not function similar to Teradici zero client firmware. For example, the SDK in ThinOS does not support USB redirection with the host card connection. This feature is mainly for workstation users working on the server remotely.
To configure the PCoIP connection, do the following:
  1. On ThinOS desktop, go to Connect Manager.
  2. Click New, and then click PCoIP.
    Figure 1. PCoIP Connection Protocol
    PCoIP Connection Protocol
  3. In the Connection Settings (PCoIP) dialog box, do the following:
    Figure 2. Connection Settings - PCoIP
    Connection Settings - PCoIP
    1. Enter the description for the PCoIP connection.
    2. Enter the IP address of the remote host card.
    3. From the Display Resolution drop-down list, select a display resolution for the PCoIP connection.
      TERA2220 supports a single display with 2560 x 1600 resolution or two displays with 1920 x 1200 resolution. TERA2240 supports two displays with 2560 x 1600 resolution or four displays with 1920 x 1200 resolution.
    4. Select either the Window mode or Full screen to set the initial view of the session.
    5. If you want to automatically connect to the session after you restart the thin client, select the Auto-connect on start-up check box.
    6. Select the Re-connect after disconnect check box if you want to automatically reconnect to a session after the session is disconnected. If you select this option, enter the wait interval in the Delay before re-connecting box. The default is 20 seconds.
  4. Click OK to save the settings.
For more information about the supported platforms and limitations, see the Dell Wyse ThinOS 8.6 Version Release Notes at www.dell.com/support.

For information about the Teradici host cards, see the Host Card documentation at www.teradici.com.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\