Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FD332 Owner's Manual

PDF

Removing the storage controller module

Prerequisites

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified service technicians.
  • NOTE: You must remove the storage controller module (SCM) to replace a faulty module.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Keep the T15 Torx screwdriver ready for the storage controller module cable screws.
  4. Keep the #2 Phillips screwdriver ready for the screws securing the storage controller module to the module holder.

Steps

  1. Open the drive drawer until the storage controller module is accessible.
  2. Loosen the screws securing the module cable to the SCM.
  3. Lift the module cable away from the SCM by holding the cable touch point.
  4. Holding the touch point, allow the module cable to slowly retract into the cable coil.
  5. Remove the screws securing the SCM to the module holder on the midplane interface module.
  6. Holding the SCM by the touch points, lift the SCM from the connector on the midplane interface module.
    Figure 1. Removing and installing the storage controller module This figure shows removing and installing the storage controller module.
    1. storage controller module
    2. screw (3)
    3. SCM cable touch point
    4. SCM cable screw (2)
    5. touch point on the SCM (4)
    6. connector on midplane interface module

Next steps

Install the storage controller module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\