Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FD332 Owner's Manual

PDF

Removing the bezel assembly

Prerequisites

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: To prevent damage to the storage sled locks, use a #2 Phillips screwdriver to turn the sled locks to lock or unlock positions.
  • NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified service technicians.
  • NOTE: You must remove the bezel assembly to replace a faulty bezel assembly or when you are replacing the chassis.
  1. Ensure that you read the Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Remove the Mini Enterprise Service Tag (MEST) and save for future use.
  4. Keep tweezers ready for the service caution label.
  5. Keep the #2 Phillips screwdriver ready.

Steps

  1. Release the service caution label from top of the storage sled by using tweezers.
  2. Remove the service caution label and save for future use.
    Figure 1. Removing and installing the service caution label This figure shows removing and installing the service caution label.
    1. service caution label
    2. storage sled
  3. Using a Phillips #2 screwdriver, turn the sled locks to lock position.
  4. Pull the drive drawer handle and open the drive drawer.
  5. Remove the screws securing the bezel assembly to the top of the sled.
  6. Turn the sled over with the bottom side of the sled facing up.
  7. Remove the screws securing the bezel assembly to the bottom side of the sled.
  8. Pull the bezel assembly out of the sled.
    Figure 2. Removing and installing the bezel assembly This figure shows removing and installing the bezel assembly.
    1. screw (7)
    2. top side of the sled
    3. bezel assembly

Next steps

Install the bezel assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\