Skip to main content

Active System Manager Version 8.1 User’s Guide

PDF

Adding clusters to existing service

To add clusters to an existing service:
  1. On the Add Cluster(s) page, add the clusters to the existing service in one of the following ways:
    • If you want to clone an existing cluster configuration to the clusters that you want to add to the service, next to New Component Settings , click Duplicate, and perform the following steps:

      1. From the Resource to Duplicate drop-down list, select a cluster to clone.

      2. In the # of Instances box, enter the number of cluster instances that you want to add to the service. Click Continue.

      3. In the Component Name box, enter the cluster name for the corresponding clusters.

    • If you want to add new cluster component, next to New Component Settings, click New, and perform the following steps:

      1. From the Select a Component drop-down list, select one of the following cluster types:
        • VMWare Cluster
        • Hyper-V Cluster

      2. Under Associated Resources, to associate the newly added cluster to the existing components in the service, select the components to associate.

      3. Click Continue.

        Based on the component type, specific settings and properties appear automatically that are required and can be edited. For more information specific to component type settings, see Component Types.

  2. Click Save.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\