Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge M830 (For Dell PowerEdge VRTX Enclosure) Owner's Manual

PDF

Installing a 2.5-inch (x4) SATA hard-drive or SSD backplane

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #2 Phillips screwdriver ready.

  4. Remove the hard-drive or SSD backplane.
    NOTE: You must remove the hard-drive or SSD backplane to replace a faulty hard-drive or SSD backplane or service other components inside the system.

Steps

  1. Align the retention screws on the hard-drive or SSD backplane cable connector with the screw holes on the system board connector.
  2. Tighten the two retention screws to secure the backplane cable connector on the system board.
  3. Install the hard-drive or SSD cage.
  4. Align the guides on the hard-drive or SSD backplane with the guide pins on the hard-drive or SSD cage.
  5. Press down on the hard-drive or SSD backplane until the tabs on the release latches engage with the slots on the chassis.
    Figure 1. Installing a 2.5-inch (x4) SATA hard-drive or SSD backplane
    The image shows installing a 2.5-inch (x4) SATA hard-drive or SSD backplane
    1. hard-drive or SSD backplane
    2. release latch (2)
    3. guide pin (5)
    4. hard-drive or SSD backplane cable
    5. retention screw on the hard-drive or SSD backplane cable connector (2)
    6. connector

Next steps

  1. Install the hard drives or SSDs in their original locations.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\