Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge M830 (For Dell PowerEdge VRTX Enclosure) Owner's Manual

PDF

Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD carrier

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the Phillips #1 screwdriver ready.

Steps

  1. Remove the four screws from the slide rails on the hard drive or SSD carrier.
  2. Slide the hard drive or SSD out of the hard drive or SSD carrier.
    Figure 1. Removing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
    This figure shows removing a 2.5-inch hard drive or SSD in a 2.5-hard drive or SSD carrier.
    1. screw (4)
    2. hard drive or SSD
    3. hard-drive or SSD carrier
    4. screw hole (4)

Next steps

  • Install a new 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier.
  • Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\