- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Real-Time Clock (RTC Reset)
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
XPS 17 9720 Service Manual
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:This laptop support M.2 2230 solid-state drive or M.2 2280 solid-state drive in both SSD slots.
NOTE:Install the solid-state drive mounting bracket, if it is not installed.
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation procedure.
Steps
- Align the notch on the solid-state drive with the tab on the solid-state drive slot.
- Slide the solid-state drive into the solid-state drive slot.
- Using the alignment post, place the solid-state drive thermal bracket over the solid-state drive.
- Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
- Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
Next steps
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\