Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell Storage MD1400 Enclosures Hardware Owner's Manual

PDF

Connecting the power cable to the power supply module

  1. Make sure that the power switch is in the OFF mode before connecting the DC power cable.
  2. Connect the DC power supply cable to the power supply module by plugging the power cables into the matching power supply module plug connector.
  3. Secure the power cables to the power supply module by fastening the power cables firmly to the system using the attached (trapped) finger screws.
  4. Install the screws to the corresponding screw holes on the system and tighten until the power connector is firmly held in place.
    Figure 1. Connecting the dc power cables
    This figure shows connecting the DC power cables to power supply module.
    1. attached (trapped) finger screws
    2. connector on the power supply cable
    3. connector on the power supply module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\