An enclosure
with redundant enclosure management contains two enclosure management
modules (EMM). You can cable your enclosure either in a single port,
redundant mode or in a multi-mode configuration. If only one EMM is
installed in your enclosure, it must be installed in EMM 0. You must
install the EMM blank in EMM 1.
NOTE: : EMMs can be removed
and installed without turning off the enclosure.
CAUTION: : It is
recommended that you do not remove an EMM while data is being transferred.
CAUTION: : Replacing or installing an EMM that is connected to a host server
causes it to end communication with the enclosure and requires a restart
of the host server.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\