Dell Command | PowerShell Provider Version 2.3 User's Guide

PDF

Configuring attributes using Dell Command | PowerShell Provider

To configure system BIOS settings using Dell Command | PowerShell Provider attributes:
  1. Set-location to DellSMBIOS: drive. See Dell Command | PowerShell Provider drive.
  2. Verify the current state of the attribute by running the following command: Get-Item -Path <path to the attribute>. See Format of the path.
    The command displays the Current Value, Possible Values and Description of the attribute you want to configure.
  3. To set the attribute, run the following command: Set-Item –Path <path to the attribute> <possible value> -Password <password>. See Password parameters.
Example: To enable the Numlock attribute when password is set, run the following command:
Set-Item –Path .\POSTBehavior\Numlock Enabled -Password <password>

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\