CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
CAUTION: The
system requires one power supply unit (PSU) for normal operation.
On power-redundant systems, remove and replace only one PSU at a time
in a system that is powered on.
Follow the safety guidelines listed in the Safety
instructions section.
Disconnect the power cable from the power source.
Disconnect the power cable from the PSU and remove
the straps that bundle and secure the system cables.
Unlatch and lift the optional cable management arm
if it interferes with PSU removal. For information about the cable
management arm, see the systems rack documentation at Dell.com/poweredgemanuals.
Steps
Press the release latch and pull the PSU out
of the chassis.
Figure 1. Removing and
installing a redundant PSU
release latch
PSU connector
power connector
PSU handle
Next steps
Install
the PSU.
NOTE: If you are removing
the PSU permanently, install a PSU blank.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
