Skip to main content

Dell Unity™ Family Unisphere® Command Line Interface User Guide

PDF

Change LUN move session settings

Format

/move/session -id <value> set [-priority {idle | low | below | normal | above | high}] [-async]

Object qualifier

QualifierDescription
-idType the ID of the move session.

Action qualifiers

QualifierDescription
-prioritySpecify the priority of the move session. Valid values are:
  • idle—Designated for move sessions that continue to mirror the host I/O.
  • low—Designated for move sessions that have the least priority over other move sessions.
  • below—Designated for move sessions that are slightly less critical than the average or normal move session.
  • normal (default)—Designated for move sessions that are appropriate for most use cases.
  • above—Designated for move sessions that are slightly more critical than the average or normal move session.
  • high—Designated for move sessions that take the highest priority over other move sessions.
-asyncRun the operation in asynchronous mode.

Example

The following command modifies the settings of a move session.

uemcli -d 10.0.0.1 -u Local/joe -p MyPassword456! /move/session –id MoveSession_1 set -priority below 
Storage system address: 10.0.0.1
Storage system port: 443
HTTPS connection

ID = MoveSession_1
Operation completed successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\