NOTE: Hover your cursor over the
icon if you want to see further information
on Peak Shift.
To enable Peak Shift, click the toggle at the
top of the page to the
On position.
NOTE: Your system BIOS already has a minimum threshold setting below which
the system always draws AC power if it is available; this BIOS setting
always takes precedence over any setting you enter here.
To select the percentage at which the system
will
Restore AC power if available system charge falls
below
, move the slider.
For example, selecting 15 percent causes the
system to switch from battery to AC power during Peak Shift if the
power remaining falls below 15 percent. While the system runs as normal on AC (direct) power,
the battery does not charge until Peak Shift ends.
To enable or disable Peak Shift for a specific
day, click the toggle next to each day of the week.
NOTE: If you have not enabled Advanced Charge for a particular
day, that day will not display on the Time Settings page, and you
will not be able to set an Advanced Charge schedule for that day.
Go back to the main Advanced Charge page and enable Advanced Charge
for that particular day.
To set the time of day when Peak Shift is
active, click
Settings.
On the
Time Settings screen, click a day of the week. Using either the circular slider
or the drop-down menus:
NOTE: You can select times in 15–minute increments—for example, you can
enter
11:15 AM or
9:30 PM.
NOTE: The circular slider represents a 24-hour period.
Activate Peak Shift: Select the time you want Peak Shift
to begin.
NOTE: If you
enable
Operate only on AC, then the time between
starting Peak Shift and operating on AC power is indicated in blue,
and the time between starting to operate on AC power and ending Peak
Shift is indicated in yellow. Green indicates the period of operation
on AC power without charging the battery.
Set a time at which the system begins to operate only on AC
power without charging the battery
: Select the
Operate
on AC power without charging battery
check box, then select
the time that you want the system to start operating on AC power without
charging the battery.
End Peak Shift: Select the time you want Peak Shift to
end.
NOTE: The
Copy the same settings to multiple days check box is
automatically cleared once you leave the page.
Select
Copy the same settings
to multiple days
. Then, in the left pane, select the days
to which these settings apply.
To save your changes, click
OK, or to discard them, click
CANCEL.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\