Error occurs while importing CMC configuration file
Description
An error occurs while importing CMC configuration file using local or remote RACADM.
Resolution
This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the command,
racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0.
Versions/Systems affected
CMC for PowerEdge FX2 1.10 or later
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\