Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

G5 5000 Service Manual

PDF

Installing the voltage regulator heat sink

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE: The voltage regulator heat sink is shipped as a separate unit and it does not ship along with the system board. Ensure to replace the voltage regulator heat sink from old system board to the new system board. Voltage regulator is required for computers that are shipped with the following processors:
  • 10th Generation Intel Core i5-10600K
  • 10th Generation Intel Core i5-10600KF
  • 10th Generation Intel Core i7-10700K
  • 10th Generation Intel Core i7-10700KF
  • 10th Generation Intel Core i9-10900K
  • 10th Generation Intel Core i9-10900KF

About this task

The following images indicate the location of the voltage regulator heat sink and provides a visual representation of the installation procedure.

Image: Installing the VR heat sink

Steps

  1. Align and place the voltage regulator heat sink on the system board.
  2. Tighten the two captive screws that secure the voltage regulator heat sink to the system board.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\