Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FC830 Owner's Manual

PDF

Removing a processor blank and DIMM blank

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove processor blank and DIMM blank when installing four processors or service other components inside the system.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

Steps

  1. Press the ejectors on both ends of the memory module sockets to open processor blank and DIMM blank.
  2. Hold the processor blank and DIMM blank by its edges and lift it away from the system.
    Figure 1. Removing a processor blank and DIMM blank
    This figure shows removing the processor blank and DIMM blank.
    1. processor blank and DIMM blank
    2. tab on the processor blank and DIMM blank (4)
    3. memory module socket (2)
    4. memory module socket ejector (2)

Next steps

  1. Install the processor and the heat sink.

  2. If you are removing a processor permanently, install the processor blank.

  3. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\