Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Creating a Virtual Router

To enable VRRP, create a virtual router. In Dell, the virtual router identifier (VRID) identifies a VRRP group.

To enable or delete a virtual router, use the following commands.
  • Create a virtual router for that interface with a VRID. INTERFACE mode vrrp-group vrid The VRID range is from 1 to 255.
    • NOTE: The interface must already have a primary IP address defined and be enabled, as shown in the second example.
  • Delete a VRRP group. INTERFACE mode no vrrp-group vrid

Example of Configuring VRRP 

Dell(conf)#int tengig 1/1
                                 Dell(conf-if-te-1/1)#
                                 vrrp-group 111
                                 Dell(conf-if-te-1/1-vrid-111)#

Example of Verifying the VRRP Configuration 

Dell(conf-if-te-1/1)#show conf
                                 !
                                 interface Tengigabitethernet 1/1
                                 
                                 ip address 10.10.10.1/24
                                 !
                                 vrrp-group 111
                                 
                                 no shutdown
                                 Dell(conf-if-te-1/1)#

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\