Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Clearing Peer Statistics

To clear the peer statistics, use the following command.

Reset the TCP connection to the peer and clear all peer statistics. CONFIGURATION mode clear ip msdp peer peer-address

Example of the clear ip msdp peer Command and Verifying Statistics are Cleared 

R3_E600(conf)#do show ip msdp peer
                                 
                                 Peer Addr: 192.168.0.1
                                 Local Addr: 192.168.0.3(639) Connect Source: Lo 0
                                 State: 
                                 Established Up/Down Time: 
                                 00:04:26
                                 Timers: KeepAlive 30 sec, Hold time 75 sec
                                 SourceActive packet count (in/out): 
                                 5/0
                                 SAs learned from this peer: 0
                                 SA Filtering:
                                 Input (S,G) filter: myremotefilter
                                 Output (S,G) filter: none
                                 R3_E600(conf)#do clear ip msdp peer 192.168.0.1
                                 R3_E600(conf)#do show ip msdp peer
                                 
                                 Peer Addr: 192.168.0.1
                                 Local Addr: 0.0.0.0(0) Connect Source: Lo 0
                                 State: 
                                 Inactive Up/Down Time: 
                                 00:00:04
                                 Timers: KeepAlive 30 sec, Hold time 75 sec
                                 SourceActive packet count (in/out): 
                                 0/0
                                 SAs learned from this peer: 0
                                 SA Filtering:
                                 Input (S,G) filter: myremotefilter
                                 Output (S,G) filter: none

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\