Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Setting up VLT

The following figure shows the sample VLT topology.

Figure 1. Sample VLT TopologySample VLT Topology

In PMUX VLT, you can choose any uplink ports for configuring VLT.

  • NOTE: Ensure the connectivity to ToR from each Aggregator.
To enable VLT and verify the configuration, follow these steps.
  1. Enable VLT in node 1 and 2.stack-unit unit iom-mode vlt CONFIGURATION mode Dell(conf)#stack-unit 0 iom-mode vlt
  2. Verify the VLT configurations.show interface port-channel brief EXEC mode 
    Dell# show interfaces port brief
                                    Codes: L - LACP Port-channel
                                    O - OpenFlow Controller Port-channel
                                    
                                    LAG      Mode  Status       Uptime      Ports          
                                    127  L2    up           00:18:22    Fo 0/33    (Up)<<<<<<<<ICL LAG
                                    Fo 0/37    (Up)
                                    L   128  L2    up           00:00:00    Fo 0/41    (Up)<<<<<<<<Uplink LAG

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\