- Notes, cautions, and warnings
- PowerEdge FC430 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing sled components
- Safety instructions
- Recommended tools
- Sled
- Inside the sled
- Cooling shroud
- System memory
- PCIe mezzanine card
- Internal Dual SD Module (IDSDM) card
- SD vFlash card
- LAN on Motherboard (LOM) riser card
- Processors
- Processor blank and DIMM blank
- Solid State Drives (SSD)
- Solid State Drive (SSD) backplane
- System battery
- System board
- Trusted Platform Module
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Dell PowerEdge FC430 Owner's Manual
Troubleshooting USB devices
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that are shipped with your product.
Steps
- Ensure that the sled is turned on.
- Check the USB device connection to the sled.
- Swap the USB device with a working USB device.
- Connect the USB devices to the sled by using a powered USB hub.
- If another sled is installed, connect the USB device to that sled. If the USB device works with a different sled, the first sled’s USB ports may be faulty. See the Getting help section.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"