Dell PowerEdge T320 Systems Owner's Manual

Installing The Control-Panel Assembly

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

Connect the control panel cable and if applicable, the VGA module cable to the control-panel assembly.
Align and insert the control-panel assembly into the slot in the chassis.
- NOTE: Ensure that you do not crimp the cables as you insert the control-panel assembly into the slot.
Push the control-panel assembly so that it is flush with the back of the slot in the chassis.
Secure the control-panel assembly to the chassis using the screw on the side of the chassis.
Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
- NOTE: Information tag lists system information such as Service Tag, NIC, MAC address, and so on.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
If applicable, install the front bezel.