Dell PowerEdge T320 Systems Owner's Manual

Installing The Power Interposer Board

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

If applicable, install the power distribution board onto the power interposer board.
Align the power interposer board with the hooks on the power supply cage and slide it into place.
Install the four screws that secure the power distribution board to the chassis.
Route the power cables through the securing clips as applicable, and connect the power cables to the system board.
Route the P3 power cable through the securing clip on the system board and connect power cable to the hard-drive backplane.
Install the power supply module(s) or power supply blank in their original locations.
Close the system.
If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.