On
VASA's Configuration Manager, click
Launch Array Manager. Alternately,
you can start the array manager by using URL:
http://<host_address>:8080/arraytree.
NOTE: If you are using static IP address, substitute a standard IP address
for
<host_address>. If you are
using DHCP, substitute a DNS name for
<host_address>.
Figure 1. Array Manager
Window
In the
Array Manager window,
click
Add Array in the
Commands section.
NOTE: vSphere supports a
Discover Arrays option
to perform automatic array discovery based on a range of RAID controller
module IP addresses that you provide. You can use either method of
specifying arrays—
Add Array or
Discover
Arrays
(if available).
Click
Add Folder to create a separate
folder to contain the storage arrays that you want to add.
In the
Add Storage Device window, enter the IP addresses for the RAID controllers module in
the storage arrays that you want to add to VASA.
Enter the RAID controller module password,
if necessary.
Repeat step 2 through
5 to add more storage arrays.
Close the
Array Manager window.
Los datos no están disponibles para el tema
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"