- Notes, cautions, and warnings
- Getting Started
- What’s new in this release
- DUP event viewer
- Zip pack elimination
- Slot information for hard drive
- Dependency
- Supported Operating Systems
- Prerequisites
- Prerequisites And Features For Systems Running Linux
- Prerequisites and Features for Systems Running Windows
- Downloading DUPs
- Downloading DUPs through Repository Manager
- Installing Device Drivers
- Installation Order of DUPs
- Best practices for using DUPs
- Other Documents You May Need
- Contacting Dell
- Using Dell Update Packages
- Update and Rollback in Lifecycle Controller Enabled Server
- Command Line Interface Reference
- Linux Troubleshooting
- Known Issues
- Diagnostic Tasks Will Not Run While a DUP Reboot is Pending
- Abnormal Termination of a DUP
- Error While Loading Shared Libraries
- Insufficient Free Physical Memory to Load the BIOS Image
- Kernel Panic While Running Storage Controller Firmware Update Packages
- Loss of Functionality While Renaming Linux DUPs
- DUPs Fail on 64-bit Red Hat Enterprise Linux Operating System
- DUP Update of Firmware Might Fail While Running in the UEFI Mode
- Messages
- DUP Message Logs
- Known Issues
- Troubleshooting for Systems Running Windows
- Trusted Platform Module and BitLocker Support
- Microsoft Windows Server 2008 User Account Control
- Frequently Asked Questions
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Dell Update Packages User's Guide
DUP Update of Firmware Might Fail While Running in the UEFI Mode
When Red Hat Enterprise Linux 6 or SLES 11 is installed and booted in a UEFI environment, flashing firmware using DUP might fail after DUP reboots the system.
DUP relies on a warm reset to enable firmware flashing. In the UEFI mode, the kernel by default performs a cold reset.
Boot the system with the reboot=k kernel command line option to enable the firmware flashing procedure to complete successfully. You could add this to /etc/grub.conf to be persistent across reboots.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\