- Notes, cautions, and warnings
- Getting Started
- What’s new in this release
- DUP event viewer
- Zip pack elimination
- Slot information for hard drive
- Dependency
- Supported Operating Systems
- Prerequisites
- Prerequisites And Features For Systems Running Linux
- Prerequisites and Features for Systems Running Windows
- Downloading DUPs
- Downloading DUPs through Repository Manager
- Installing Device Drivers
- Installation Order of DUPs
- Best practices for using DUPs
- Other Documents You May Need
- Contacting Dell
- Using Dell Update Packages
- Update and Rollback in Lifecycle Controller Enabled Server
- Command Line Interface Reference
- Linux Troubleshooting
- Known Issues
- Diagnostic Tasks Will Not Run While a DUP Reboot is Pending
- Abnormal Termination of a DUP
- Error While Loading Shared Libraries
- Insufficient Free Physical Memory to Load the BIOS Image
- Kernel Panic While Running Storage Controller Firmware Update Packages
- Loss of Functionality While Renaming Linux DUPs
- DUPs Fail on 64-bit Red Hat Enterprise Linux Operating System
- DUP Update of Firmware Might Fail While Running in the UEFI Mode
- Messages
- DUP Message Logs
- Known Issues
- Troubleshooting for Systems Running Windows
- Trusted Platform Module and BitLocker Support
- Microsoft Windows Server 2008 User Account Control
- Frequently Asked Questions
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Dell Update Packages User's Guide
System Reboot Required
Certain packages, such as those that update the system BIOS, require a reboot for the new software to take effect. After you apply an update that requires a reboot, you must restart the system to complete the update.
You have the option of choosing to defer the reboot until another time as long as you do not turn off the system. This feature is primarily intended to allow you to apply any number of updates together and perform the system reboot after the last update has been applied. If this process is interrupted, for example, through a power interruption, you must repeat the updates. Therefore, it is recommended that you schedule updates for a time when the reboot can take place immediately after you apply the last update.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\