Microsoft Windows 10 IoT Enterprise for Dell Wyse Thin Clients Administrator’s Guide

Booting from UEFI USB key

The following table provides the guidelines to boot from a UEFI USB key on the supported thin client devices:

Table 1. Booting from a UEFI USB key . The following table provides the guidelines to boot from a UEFI USB key on the supported thin client devices:
Supported thin clients	Guidelines to boot the thin client
Wyse 5020 thin client with Win10 IoT (D90Q10) Wyse 7020 thin client with Win10 IoT (Z90Q10) Wyse 7020 accelerated graphics thin client with Win10 IoT (Z90QQ10)	To boot the thin client from a UEFI USB key, do the following: During system start up, press `Delete` when you see a Wyse logo. The BIOS Setup screen is displayed. Set the Secure Boot to Disabled. Set the Boot from USB to Enabled. Save the changes and exit. From the pop-up menu, select your USB key, and boot as Normal.
Wyse 5060 thin client Wyse 7040 thin client Latitude 3480 mobile thin client Latitude 5280 mobile thin client Latitude 3190 mobile thin client Latitude 5490 mobile thin client	To boot the thin client from a UEFI USB key, do the following: During system start-up, press `F2` when you see a Dell logo. The BIOS Setup screen is displayed. Set the Secure Boot to Disabled. Click System Configuration > USB Configuration , and select the Enable USB Boot Support check box. Save the changes and exit. During system start up, press `F12`, and select USB key in the boot menu. NOTE: You can boot the Windows 10 IoT Enterprise (WIE10) 64–bit devices if the secure boot is set to Disabled. However for security purposes, this is not recommended.