Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

PDF

Diagnose RAID Controller Module

Description

This command runs diagnostic tests on the RAID controller module.
The testID parameter takes the following options, which you can use to verify that a RAID controller module is functioning correctly:
  • 1 — Reads the test
  • 2 — Performs a data loop-back test
  • 3 — Writes the test
The diagnostic tests consist of loop-back tests in which data is written to physical disks and read from the physical disks.

Syntax

diagnose controller [(0 | 1)]
                                 loopbackPhysicalDiskChannel=(allchannels | (1 | 2))
                                 testID=(1 | 2 | 3)
                                 [patternFile=”
                                 filename”]

Parameters

Parameter Description
controller RAID controller module on which to run the diagnostic tests. Valid RAID controller module identifier values are 0 and 1. The identifier value is 0 for the RAID controller module on the top and 1 for the RAID controller module on the bottom when viewed from the rear of the enclosure. You must put brackets ([ ]) around the RAID controller module identifier. If you do not specify a RAID controller module, the MD storage management software returns a syntax error.
loopbackPhysicalDiskChannel Physical disk channel on which to run the diagnostic tests. You can choose to run the diagnostics on all channels or select a specific channel on which to run diagnostics. Valid physical disk channel values are 1 or 2.
  • NOTE: When you run a data loopback test, you can optionally specify a file that contains a data pattern. If you do not specify a file, the firmware provides a default pattern.
testID Identifier for the diagnostic test to run. The identifier and corresponding tests are:
  • 1 — Reads the test
  • 2 — Write test
  • 3 — Data loop-back test
  • NOTE: When you run a data loop-back test, you can optionally specify a file that contains a data pattern. If you do not specify a file, the RAID controller module firmware provides a default pattern.
patternFile File path and file name of the file that contains a data pattern to use as test data. Enclose the path and file name with quotation marks (" ").

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \