메인 콘텐츠로 이동
문의처

Dell Precision Tower 5810/7810/7910/1700MT/1700SFF/3620MT and Rack 7910 Thunderbolt Add-In-Cards Setup Guide

PDF

Setting up the Thunderbolt Add-In-Card

This section describes in brief on how to install the thunderbolt add-in-cards on a Dell Precision Tower 5810, 7810, 7910, Rack 7910, T1700 MT, T1700 SFF and 3620 MT.

Pre-requisite actions before setting up a Thunderbolt card:

  1. To utilize a Thunderbolt Add-In-Card (AIC) make sure you have a compatible Thunderbolt system board. Figure displaying connecting display port to DisplayPort cable.
  2. Install Thunderbolt software before installing the Add-In-Card (AIC).
NOTE: Thunderbolt card supports windows operating system only. Linux operating system is not supported.

To setup a Thunderbolt Add-In-Card

  1. Connect the GPIO cable to the GPIO header on the system board.
    NOTE: There is a 5-Pin keyed GPIO cable, one end goes to the card, and the other end goes to the GPIO header on the system board.
    • For Precision Tower 7910: the Thunderbolt AIC is placed in CPU1 slot 3
    • For Precision Tower 5810/T7810: the Thunderbolt AIC is placed in CPU1 slot 5
    • For Precision Rack 7910: the Thunderbolt AIC NOT supported
    • For Precision T1700 MT: the Thunderbolt AIC is placed in slot 4
    • For Precision T1700 SFF: the Thunderbolt AIC is placed in slot 1
    • For Precision T3620 MT: the Thunderbolt add in card (AIC) is placed in slot 3
    Figure displaying GPIO cable to the GPIO header
  2. Connect the display port to DisplayPort cable. Figure displaying connecting display port to DisplayPort cable.

본 콘텐츠를 평가해주십시오.

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
0/3000 characters
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  평점(별 1~5개)을 매겨주십시오.
  문서가 도움이 되었는지 여부를 선택하십시오.
  의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.