CAUTION:This procedure is intended to
be performed by Dell Support only.
CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the slots on the control panel board with the metal
standoffs on the control panel and slide the control panel board into
the control panel.
When firmly seated, the KVM connectors on the control
panel board align with the slots on the control panel.
Attach the two screws to secure the control panel board
to the control panel.
Reconnect the power cable to the control panel board.
Reconnect the LCD module cable to the control panel board.
Reinstall the LCD cable holder.
Reinstall the control panel.
Reconnect the control panel cable to its connector on the
system board.
Reinstall the cooling fan assembly.
Reinstall the cooling shroud.
Close the system.
If applicable, place the system upright on a flat, stable
surface and rotate the system feet outward.
Reinstall the hard drives.
Reinstall the server modules.
Reconnect the enclosure to its electrical outlet and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating system commands
or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\