Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell Storage with Microsoft Storage Spaces Cabling Guide

PDF

Server and enclosure port numbering

The following figures show the enumeration of the ports on the HBAs within the server.
Figure 1. Rear view of DSMS 630 server showing location of HBA ports This image shows rear view of DSMS 630 server showing location of HBA ports.
Figure 2. Rear view of DSMS 730 server showing location of HBA ports This image shows the rear view of DSMS 730 server showing location of HBA ports.
  • NOTE: Dell does not support having HBAs located in the lower two, full-height, PCI slots (slots 5 and 7).
The following figures show the enumeration of the ports on the HBAs within the storage enclosure.
Figure 3. Rear view of DSMS 3060e storage enclosure showing location of HBA ports This image shows rear view of DSMS 3060e storage enclosure showing location of HBA ports.
Figure 4. Rear view of DSMS 1400 series storage enclosure showing location of HBA ports This image shows rear view of DSMS 1400 series storage enclosure showing location of HBA ports.
Use these figures as a point of reference when cabling the storage enclosures to the servers. The SAS HBAs installed in the servers in your solution may not always match the figures displayed here. However, the same cabling guidance is applicable.
  • NOTE: When you view the back of a server, HBA ports are numbered left to right, and then top to bottom.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \