Ga naar hoofdinhoud
Uitloggen

Welkom bij Dell

Mijn account
  • Snel en eenvoudig bestellen
  • Bestellingen en de verzendstatus bekijken
  • Een lijst met producten maken en openen
  • Beheer uw Dell EMC locaties, producten en contactpersonen op productniveau met Company Administration.
Inloggen Een account maken Inloggen bij Premier Aanmelden voor partnerprogramma
Contact

Uw Dell.com-winkelwagentjes

Dell Lifecycle Controller GUI v2.30.30.30 User's Guide

PDF

Assigning a system and/or setup password

The password jumper enables or disables the System Password and Setup Password features. For more information on the password jumper settings, see System board jumper settings. .
  • NOTE:

You can assign a new System Password or Setup Password or change an existing System Password or Setup Password only when the password jumper setting is enabled and Password Status is set to Unlocked. If the Password Status is set to Locked, you cannot change the System Password or Setup Password.

If the password jumper setting is disabled, the existing System Password and Setup Password is deleted and you need not provide the system password to boot the system.

  1. To enter System Setup, press F2 immediately after a power-on or reboot.
  2. In the System Setup Main Menu, select System BIOS and press Enter.
  3. In the System BIOS screen, select System Security and press Enter.
  4. In the System Security screen, verify that Password Status is Unlocked.
  5. Select System Password, enter your system password, and press Enter or Tab. Use the following guidelines to assign the system password:
    • A password can have up to 32 characters.
    • The password can contain the numbers 0 through 9.
    • Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
    A message prompts you to re-enter the system password.
  6. Re-enter the system password and click OK.
  7. Select Setup Password, enter your system password and press Enter or Tab. A message prompts you to re-enter the setup password.
  8. Re-enter the setup password click OK.
  9. Press Esc to return to the System BIOS screen. Press Esc again, and a message prompts you to save the changes.
    • NOTE: Password protection does not take effect until the system reboots.

Beoordeel deze inhoud

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
0/3000 characters
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Geef een beoordeling (1-5 sterren).
  Selecteer of het artikel nuttig is of niet.
  Opmerkingen mogen geen speciale tekens bevatten: <>() \