Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

Dell PowerEdge R730 Owner's Manual

PDF

Installing expansion card risers

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. If removed, install the expansion card(s) into the expansion card riser 1.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Align the expansion card riser with the connectors and the riser guides on the system board.
  2. Lower the expansion card riser into place until the expansion card riser is fully seated in the connector.
    Figure 1. Installing the expansion card riser 1
    This figure shows installing the expansion card riser 1
    1. expansion card riser 1 cage
    2. expansion card riser 1
    3. riser guide-back (right)
    4. riser guide-back (left)
    5. expansion card riser 1 connector
    6. riser guide-front
    Figure 2. Installing the expansion card riser 2
    This figure shows installing the expansion card riser 2
    1. power connector (for GPU cards)
    2. expansion card riser 2
    3. riser guide-back
    4. expansion card riser 2 connector
    5. riser guide-front
    Figure 3. Installing the expansion card riser 3
    This figure shows installing the expansion card riser 3
    1. riser guide-front
    2. power connector (for GPU cards)
    3. expansion card riser 3
    4. riser guide-back
    5. expansion card riser 3 connector

Next steps

  1. Install the expansion card(s) into the expansion card risers 2 or 3.
  2. Follow the procedure listed in the After working inside your system section.
  3. Install any device drivers required for the card as described in the documentation for the card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\