Options to set up
iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from
iDRAC . You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings utility
See
Integrated Dell Remote Access Controller User's Guide
Dell Deployment Toolkit
See
Dell OpenManage Deployment Toolkit User's Guide available on the
OpenManage manuals page.
Dell Lifecycle Controller
See
Dell Lifecycle Controller User's Guide available at
iDRAC manuals
CMC Web interface
See
Chassis Management Controller User's Guide
available on the
CMC manuals page.
You must use the default
iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for
iDRAC .
NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.
NOTE: Ensure that you change the default user name and password after setting up the
iDRAC IP address.