VxRail E660N

This document highlights minimum, recommended, and latest code versions for Dell Technologies Enterprise and Datacenter Infrastructure products. We carefully evaluate and monitor code deployment data to ensure that product releases meet our stringent expectations to provide our customers with reliable products and solutions.

Missing PSNT serial number on nodes that shipped with VxRail version 7.0.450 or 8.0.100 cause issues with VxRail cluster creation or node expansion operations.

This event code indicates "The fault-tolerant pair of RAID controllers <RAID controller 1> and <RAID controller 2> can have issues in their PCIe fabric because both controllers are on the same PCIe fabric."

This event code indicates "The <name> voltage redundancy is degraded."

This event code indicates "Disk drive bay temperature is less than the lower warning threshold."

This event code indicates "Power supply cable has been removed from <PSU Sensor Name>."

This event code indicates "The System Input Power Cap is too low to be enforced using the current Power Supply configuration."

This event code indicates that "An unsupported physical disk drive has been detected."

This is a general troubleshooting guide to help identifying if there is a problem with a physical disk in vSAN Clusters.

Vmware-updatemgr service does not start after vCenter certificate is replaced.

The host management account on VxRail is disconnected.

This article details reasons why VxRail 7.0.370 is not available for upgrades and recommendations for customers who already upgraded to 7.0.370 on certain VxRail models.

Customizing the VxRail Initial IP Address

The 'bmc' health-check verifies that the Platform Service is running and the Baseboard Management Controller (BMC), revision can be read.

These tests check the disk free-space (df) on the VxRM Virtual Machine partition: 'df_store2'

Upgrade fails during firmware staging process with error: Schedule firmware using VxRail Platform Service failed with timeout

VxRail: Node addition failing with "vmnicX on host x cannot communicate with other hosts on VLAN X"

On August 20, 2021, Dell Technologies announced the Next-Generation consolidated connectivity solution availability for Secure Connect Gateway 5.0 (servers, networking, data storage, data protection, hyperconverged and converged systems). It provides customers with a single solution for managing their entire Dell environment in the data center.

Host profiles are not supported on VxRail or VCF on VxRail. There are currently no plans to support this in the future.

How to resolve "Failure detected on Internal Dual SD Module SD1"

Support iDRAC events monitor: CERT331

Event VXR128016 is reported when the node management account password expires in 14 days.

Support iDRAC events monitor: THRM0018

PowerEdge connected Dell NVMe SSDs with the Limited Retry (LR) bit set may experience an increase in failures due to elevated media and data‑integrity error rates.

This article explains why Dell initiates automated secure connect-in sessions on VxRail systems connected through Secure Connect Gateway (SCG).

This procedure explains how to re-create a host management account.

Upgrade cannot continue due to management accounts having the same username.

This article explains Dell guidelines on company administrator assignment.

This article explains how to assign an Initial Company Administrator.

This article explains how to promote Company Administrators.