Articles
Tooltip title
Select a category and then a related component to find articles about specific hardware and software.
Invalid entry. Please use only Letters, numbers and any special characters except <>)(%/;,=#-/*
30 out of 672 shown
672 out of 672 shown
In some migration scenarios, the OpenManage Enterprise 4.0 target import operation may fail with an error 'Failed to decrypt backup archive' during migration. Use the following article to help in troubleshooting this scenario and various ways to address the failure.
Updated: May 19, 2026
ID: 000221490
The Dell HBA465e or HBA355e SAS host bus adapter (HBA) may be supplied as a drop in box (DIB) item alongside PowerEdge servers. This article provides direction on selecting an appropriate PCI-e slot.
Updated: May 19, 2026
ID: 000220555
Initiating a graceful restart or shutdown using Redfish APIs may fail for the Windows Server Operating System.
Updated: May 21, 2026
ID: 000224986
The server fails to power on after a system crash is encountered and LifeCycle Log (LC Log) records a watchdog event from iDRAC.
Updated: May 21, 2026
ID: 000224883
Dell solid state drive (SSD) fails after system reports low environment operating temperature.
Updated: May 20, 2026
ID: 000224458
This article provides information about PERC ECC messages that are seen due to firmware memory handling issues.
Updated: May 20, 2026
ID: 000223832
PERC H750, H755, and H755N controllers may experience single or multi-bit ECC messages.
Updated: May 20, 2026
ID: 000223831
Microsoft Hyper-V Virtual Machine (VM) Live Migration may fail or no LUNs are mapped after powering on VMs due to Windows architecture and hardware configuration limiting the number of vFC LUNs.
Updated: May 20, 2026
ID: 000223671
The issue is cosmetic. There is no functional impact. The lspci -v command requires certain labels to read. Labels are missing from the current Basic Input Output System (BIOS) but are added to June block BIOS v2.2.4.
Updated: May 20, 2026
ID: 000223577
PowerEdge customers using Broadcom NXE adapters in VMware ESXi may experience unexpected results when attempting to tune port parameters. Particularly in configurations with multiple NXE adapters present, understanding the port ordering from both a VMware (vmnicX) and serverPCI-e Slot-Bus-Device-Function (SBDF) may be helpful to select the appropriate commands.
Updated: May 20, 2026
ID: 000223479
Dell PowerEdge server with a Broadcom BCM57414 PCIe adapter could encounter intermittent network-disconnected problem in a VMware NSX-T environment.
Updated: May 20, 2026
ID: 000223469
Dell Intel E810-C adapters do not support disabling the Virtual Machine Device Queue (VMDQ) loopback feature using "Intnetcli" tool.
Updated: May 20, 2026
ID: 000223462
PowerEdge server intermittently encounters a UEFI iSCSI Boot From SAN (BFS) fatal error 8 upon booting with the PowerStore appliance.
Updated: May 20, 2026
ID: 000223454
VMware vCenter registration may fail in OMEVV 1.3 with a custom certificate chain installed in OpenManage Enterprise (OME) or vCenter.
Updated: May 20, 2026
ID: 000223404
Dell PowerEdge 16G: VMware vSphere Error: Skipping interrupt routing entry with bad device number: 176
Updated: May 20, 2026
ID: 000223051
Slow insertion of a SAS or SATA drive in PowerEdge 15G or 16G Servers with a PERC or HBA controller configuration causes a "No Access" bit to be set, leading to an inability to blink and unblink drives.
Updated: May 20, 2026
ID: 000222941
On an ESXi host, if the Flow Control setting on the BCM5720 is modified without a cable inserted, the network interface card (NIC) may fail to establish a link when a cable is later inserted. The issue does not occur if the setting is modified with a cable inserted in the NIC port.
Updated: May 20, 2026
ID: 000222793
Dell Samsung Serial Attached SCSI (SAS) PM1653 and PM1655 solid state drives may report excessive Sense Key faults 0x3, 0x11, 0x0, or 0x4, 0x29, 0x4. These faults have the potential to cause unexpected drive issues.
Updated: May 20, 2026
ID: 000222201
Dell PowerEdge Server: 15G and 16G Intel-based systems may fail with bugcheck 0x139 after installing the Intel chipset drivers or Matrox video driver.
Updated: May 20, 2026
ID: 000222177
When installing or restarting the ISM 5.1.1 on an ESXi 8.x environment, the VMK interface for BMC_Network vSwitch gets configured with a DHCP assigned address instead of static.
Updated: May 20, 2026
ID: 000221985
No option to disable Virtualization Technology or x2APIC in F2 system setup under processor settings. This occurs when a system is populated with four processors.
Updated: May 20, 2026
ID: 000221937
Dell Enterprise SAS, SATA SSD: SMART predictive failures triggered by remaining write endurance falling below the threshold
Updated: May 19, 2026
ID: 000221846
This article explains why the Windows Boot Drive (hosting the C:\ volume) may show as removeable media in Windows and how to override the behavior when necessary.
Updated: May 19, 2026
ID: 000221557
PowerEdge R860 and R960 servers with a Medium Core Count (MCC) CPU with 96GB DIMMs fail to recognize the memory with a critical error at POST.
Updated: May 19, 2026
ID: 000221528
The link speed of a NVIDIA ConnectX-7 Single Port NDR200 may show as Single Data Rate (SDR) in the IDRAC.
Updated: May 19, 2026
ID: 000221452
After a cold boot of the server, the Intel IPU E2100-CCQDA2 may present PR8 entries in the Lifecycle log.
Updated: May 19, 2026
ID: 000221450
iDRAC user interface and LSPCI show multiple PCIe Functions for the Intel Infrastructure Processing Unit (IPU) E2100-CCQDA2.
Updated: May 19, 2026
ID: 000221412
If a bond is created in Linux using the Intel Infrastructure Processing Unit (IPU) E2100-CCQDA2, the bond does not come online.
Updated: May 19, 2026
ID: 000221411
Network port enumeration on Windows Server 2022 with Dell network adapters may swap port designations.
Updated: May 19, 2026
ID: 000221408
When in a SNAPI enabled configuration, the Dell Mellanox Ethernet and InfiniBand NICs may display 0000:0000:0000:0000 as the virtual node GUID for the second partition.
Updated: May 19, 2026
ID: 000221406