PowerEdge T150

This article explains how to create and import an iDRAC certificate.

This article provides steps to troubleshoot a chassis intrusion, chassis open message for PowerEdge servers.

This document answers questions about SupportAssist Enterprise.

Installation of January 10, 2023 patch KB5022291 on Windows Server 2022 may result in Blue Screen error on the following systems and configurations. Dell 14G PowerEdge Server with Intel Optane persistent memory Series 100 configured in App Direct mode is affected. Dell 15G PowerEdge Server with Intel Optane persistent memory Series 200 configured in App Direct mode is affected. Note: Memory Settings configured in Memory Mode in the BIOS function correctly with KB5022291 or higher version of Windows Server 2022 updates. Optane Series 100 Memory Mode is Persistent Memory set to Off. Optane Series 200 Memory Mode has Optane DIMMs disabled under Memory Mapout.

The below article is a workaround mechanism to recover PowerEdge systems from critical log entry "SWC5008 Unable to access Front LED Panel because of a hardware error condition" for a few versions of the iDRAC.

NVIDIA has updated the signing certificate for its UEFI network driver from Microsoft UEFI CA 2011 to Microsoft UEFI CA 2023. PowerEdge 17G platforms already trust the CA 2023 certificate, but 15G/16G and earlier servers require a BIOS update released in December 2025. Systems without this updated certificate support may fail to initialize the NIC UEFI driver when Secure Boot is enabled.

PowerEdge T150/R250/R350/T350 BIOS version 1.13.0 shows an incorrect release date in the operating system (OS) due to a System Management BIOS (SMBIOS) cosmetic issue.

Server BIOS Update Guidelines for Microsoft Secure Boot Certificates are provided in this article.

PowerEdge 14G, 15G, 16G, and 17G servers skip Preboot eXecution Environment (PXE) boot when an "Unavailable" entry is last in the boot order.

Fans reporting FAN0000/FAN0001 errors (RPM below warning or critical) should be removed and swapped to another connector; if the error follows the fan, replace it.

Dell PowerEdge Toshiba MG08 and MG09 hard drives may encounter uninterruptible Background Media Scanning (BMS), causing I/O errors, or timeouts.

This article provides information about the LIC008 error seen when importing the IDRAC License.

This article provides information about how to verify if a Network Interface Card (NIC) is compatible with a PowerEdge Server.

This article provides information about CPU Machine Check errors and common causes and proper handling when errors are seen.

Unsure about the procedure to update a specific component's firmware in a PowerEdge system? Learn how to in this specific article.

Dell Samsung PM893 SSDs with Firmware HJ55 or Earlier Experience Premature SMART Failures

PowerEdge: Dell service support for end of industry production of 2.5" 15k RPM SAS hard drives

Dell Technologies advises against downgrading Hard Drive or SSD firmware, except in validated scenarios, due to unpredictable results and version reporting issues.

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

PowerEdge servers crash with PCIe fatal errors while updating Kioxia CM6 NVMe drive firmware.

CPUs can be perceived to be hot while server is idle.

Beginning with 15G PowerEdge, servers are offered in configurations that report more drive connections than are physically available.

Dust or chemical contamination at the endface of a fiber optic LC connector or transceiver module impedes signaling. Dell engineering teams have verified cases in which a fully functional port appears to be a bad port because dirty optical connectors manifest as a port failing loop testing with acceptable power measurement levels. Cable connectors should be cleaned and when stored must be protected from dust particle or chemical contamination.

During continuous reboot testing, the system may stop responding during the shutdown phase due to an internal error (CPU0000) on PowerEdge T150, R250, R350, T350 systems.

Seagate Summit SAS/SATA drives report medium errors or sense key 3/11 on PowerEdge and PowerVault systems due to a firmware issue causing weak writes to a drive sector.

In some instances, the firmware update job may fail to initiate when performing a firmware update through available iDRAC interfaces.

OpenManage Enterprise integration for VMware vCenter may fail to Unmanage hosts with error "UNMANAGE_REMOVE_MEL_FAILURE"

A stop during POST is possible after a customer changes Secure Boot Policy from either Standard or Custom to VMware Boot or Linux Boot.

This article describes the different type of controllers and the ways in which they should be reseated.

Warning messages regarding "icen_SetRxQueueFilter" and "Failed to add cloud filter" in ESXi 8 VMware VMkernel log.