PowerEdge R450

이 문서에서는 IDRAC 라이선스를 가져올 때 표시되는 LIC008 오류에 대한 정보를 제공합니다.

이 문서에서는 NIC(Network Interface Card)가 PowerEdge 서버와 호환되는지 확인하는 방법에 대한 정보를 제공합니다.

NVIDIA has updated the signing certificate for its UEFI network driver from Microsoft UEFI CA 2011 to Microsoft UEFI CA 2023. PowerEdge 17G platforms already trust the CA 2023 certificate, but 15G/16G and earlier servers require a BIOS update released in December 2025. Systems without this updated certificate support may fail to initialize the NIC UEFI driver when Secure Boot is enabled.

PowerEdge servers do not support operating system installation, or boot from direct CPU‑attached NVMe SSD drives if the metadata format size is not set to 0.

PowerEdge connected Dell NVMe SSDs with the Limited Retry (LR) bit set may experience an increase in failures due to elevated media and data‑integrity error rates.

Server BIOS Update Guidelines for Microsoft Secure Boot Certificates are provided in this article.

PowerEdge 14G, 15G, 16G, and 17G servers skip Preboot eXecution Environment (PXE) boot when an "Unavailable" entry is last in the boot order.

FAN0000/FAN0001 오류(경고 미만의 RPM 또는 위험)를 보고하는 팬은 제거한 후 다른 커넥터로 교체해야 합니다. 팬에서 오류가 발생하면 팬을 교체합니다.

Dell PowerEdge Toshiba MG08 and MG09 hard drives may encounter uninterruptible Background Media Scanning (BMS), causing I/O errors, or timeouts.

Encountering PR8 errors in the LifeCycle (LC) log when using a BlueField-3 (BF3) Data Processing Units (DPU) card (DPN: HFWRM).

Dell Chicony power supply (X1HXF) reports an Under Voltage Fault event PSU0034.

This article provides information about CPU Machine Check errors and common causes and proper handling when errors are seen.

Unsure about the procedure to update a specific component's firmware in a PowerEdge system? Learn how to in this specific article.

Dell Samsung PM893 SSDs with Firmware HJ55 or Earlier Experience Premature SMART Failures

New deployments of OpenManage Enterprise 4.4.0 are experiencing service failures after configuring the time zone for GMT +02:00 Helsinki, Kyiv, Riga, Sofia, Tallinn, Vilnius. The issue is only seen on fresh deployment of OpenManage Enterprise (OME) 4.4.0 on Hyper-V. Deploying OpenManage Enterprise (OME) on other hypervisors is not impacted.

R7725, R6725, R7715 및 R6715의 CPU 코어 수가 올바르게 인식되지 않습니다.

PowerEdge: 2.5" 15k RPM SAS 하드 드라이브의 산업 종료 생산에 대한 Dell 서비스 지원

Dell Technologies advises against downgrading Hard Drive or SSD firmware, except in validated scenarios, due to unpredictable results and version reporting issues.

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

이벤트 후 PowerEdge 15G 서버가 응답하지 않거나 응답을 중지PST0210.

During Windows Server 2025 installation by iDRAC virtual media, a disk with size 0 B is displayed on the drive selection page.

Leveraging the 'Reboot Required' filter and selecting all items in this filtered view results in the 'make compliant' job applying all non-compliant firmware components. An unexpected reboot of the target is seen as components that do require a restart are deployed to the target. The issue is only seen if selecting all objects and using the 'Reboot Required' filter. All other filters work as designed.

Performing a "yum update" check for Red Hat Enterprise Linux or SuSE Linux for Enterprise Servers updates may fail due to improper iDRAC RPM in the Dell YUM repository on linux.dell.com.

PowerEdge servers crash with PCIe fatal errors while updating Kioxia CM6 NVMe drive firmware.

DSU and SUU may not inventory any server components due to a crash caused in the invcol.exe module. Inventory Collector 24.09 and newer is no longer fully compatible with Windows Server 2016.

CPUs can be perceived to be hot while server is idle.

Various Dell enterprise products behave unexpectedly if IPMI is intentionally disabled from communicating between the operating system and iDRAC. This can be done by disabling the "In-band Management Interface" setting in BIOS System Security settings.

Dust or chemical contamination at the endface of a fiber optic LC connector or transceiver module impedes signaling. Dell engineering teams have verified cases in which a fully functional port appears to be a bad port because dirty optical connectors manifest as a port failing loop testing with acceptable power measurement levels. Cable connectors should be cleaned and when stored must be protected from dust particle or chemical contamination.

ESXi 8.0 U3 설치 중에 시스템 응답 중지 또는 PSOD(Purple Screen Of Death)가 표시됨

iDRAC Service Module (iSM) 5.4 and older versions fail to upload SupportAssist collections back to Dell. A "handshake API" error occurs. This upload feature has been deprecated due to the receiving servers at Dell had been decommissioned.