Removal
Base Cover
Identify the base cover highlighted in blue
Loosen the captive screws that secure the base cover to the system base.
Using a plastic scribe or a flat head screwdriver, gently pry clips on the base cover to release them from the slots on the system base.
Lift the base cover off the system base.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board and unroute the cable from the routing clip.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity
Memory Module
Identify the memory module highlighted in blue
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board
Install
Memory Module
Identify the memory module location highlighted in blue
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable highlighted in blue
Route the battery cable through the routing clip and connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue
Align the base cover tabs to the slots on the edges, press the edges of the cover until it clicks into place.
Tighten the captive screws that secure the base cover to the system base.