Removal
Side Cover
Identify the side cover highlighted in blue.
Using a phillips screwdriver to turn the side panel latch to the unlocked position.
Pull the release latch to release the side cover from the system.
Push the latch and release the side cover from the system.
Lift the side cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the top air shroud at the grip points and pull it upwards out of the system.
PCIe Holder
Identify the PCIe holder highlighted in blue.
Disconnect the PCIe power cables from the PCIe holder.
Remove the PCIe power cables from the slots on the PCIe holder.
Push the PCIe holder lock into the unlock position.
Push the latch lift and remove the PCIe holder out of the system.
Powered Graphics Card
Identify the powered graphics card highlighted in blue.
Disconnect the PCIe power cable from the connector on the graphics card.
Push the PCIe latch to open the PCIe door.
Lift the graphics card away from the graphics card slot.
Install
Powered Graphics Card
Identify the powered graphics card location highlighted in blue.
Align the powered graphics card with the PCIe slot on the system board.
Using the alignment post, push the graphic card connector firmly into the PCIe slot and press down firmly.
Close the PCIe door, locking it into position.
Connect the PCIe power cable from the connector on the graphics card.
PCIe Holder
Identify the PCIe holder location highlighted in blue.
Align and place the PCIe holder on the slot over the front fan.
Push the PCIe holder lock into the lock position to secure the PCIe holder to the system.
Route the PCIe power cables to the slots on the PCIe holder.
Connect the PCIe power cables to the PCIe holder.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the top air shroud over the heat sink and system board.
Install and press the top air shroud down until the tabs click into place.
Side Cover
Identify the side cover location highlighted in blue.
Align the tabs with the slots and install the side cover on the system.
Use a Phillips screwdriver to turn the side-panel latch to the locked position.