Removal
Side Cover
Identify the side cover highlighted in blue.
Using a phillips screwdriver to turn the side panel latch to the unlocked position.
Pull the release latch to release the side cover from the system.
Push the latch and release the side cover from the system.
Lift the side cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the top air shroud at the grip points and pull it upwards out of the system.
Power supply unit
Identify the power supply unit highlighted in blue.
Disconnect the ATX CPU processor power cables from its connectors on the system board.
Open the clips on the power supply cover.
Unroute the CPU ATX power cables.
Remove the screws that secure the power supply cover from the system.
Slide and lift the power supply cover from the system.
Disconnect the SATA power cable from the ATX SYS connector on the system board.
Disconnect the PCIe power cables from the PCIe holder.
Open the bottom air shroud cover.
Unroute the PCIe power cables.
Remove the screws that secure the power supply unit from the system.
Slide and lift the power upply unit off the system.
Install
Power supply unit
Identify the power supply unit location highlighted in blue.
Place the power supply unit on the system and slide it towards the back of the system.
Install the screws to secure the power supply unit to the system.
Route the PCIe power cables.
Close the bottom air shroud cover.
Connect the PCIe power cables to the slots on the PCIe holder.
Connect the SATA power cable to the ATX SYS connector on the system board.
Align and place the power supply cover over the power supply unit.
Install the screws to secure the power supply cover to the system.
Route the CPU ATX power cables.
Close the clips on the power supply cover.
Connect the ATX CPU processor power cables to its connectors on the system board.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the top air shroud over the heat sink and system board.
Install and press the top air shroud down until the tabs click into place.
Side Cover
Identify the side cover location highlighted in blue.
Align the tabs with the slots and install the side cover on the system.
Use a Phillips screwdriver to turn the side-panel latch to the locked position.