Removal
Cable Cover
Identify the cable cover highlighted in blue.
Slide the cable cover lock to release the cable cover from the chassis.
Slide and lift the cable cover off the back of the chassis.
Dust Filter
Identify the dust filter highlighted in blue.
Pry and remove the dust filter from the front cover.
Left Side Cover
Identify the left side cover highlighted in blue.
Loosen the screws that secure the left side cover to the chassis.
Slide and lift the left side cover from the chassis.
Front Cover
Identify the front cover highlighted in blue.
Gently pry and release the tabs that secure the front cover to the chassis.
Rotate the front cover outwards and lift it away from the chassis.
Drive Bay
Identify the drive bay highlighted in blue.
Disconnect the optical drive data and power cables from the optical drive.
Unroute the optical drive data and power cables from the routing guide on the drive bay.
Disconnect the hard drive data and power cables from the hard drive.
Lift the drive bay at an angle to release the tabs from the chassis.
Slide and remove the drive bay from the chassis.
Memory Module
Identify the memory module highlighted in blue.
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Remove the memory module from the memory module slot.
Install
Memory Module
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the memory module slot.
Press the memory module down until it clicks into place.
Drive Bay
Identify the drive bay location highlighted in blue.
Slide and secure one side of the drive bay to the chassis.
Press down the other end of the drive bay securing the tabs on the drive bay with the slots on the chassis.
Connect the hard drive data and power cables to the hard drive.
Connect the optical drive data and power cables to the optical drive.
Route the optical drive data and power cables through the guide on the drive bay.
Front Cover
Identify the front cover location highlighted in blue.
Align the front cover tabs into the slots on the chassis.
Insert and rotate the front cover towards the chassis and press it into place.
Left Side Cover
Identify the left side cover location highlighted in blue.
Slide and install the left side cover into the chassis.
Tighten the screws that secure the left side cover to the chassis.
Dust Filter
Identify the dust filter location highlighted in blue.
Align the tabs on the dust filter with the grooves on the front cover, then press it into place.
Cable Cover
Identify the cable cover location highlighted in blue.
Align the tabs on the cable cover to the slots on the back of the chassis.
Insert the tabs on the cable cover into the slots on the back of the chassis and slide it downward.
Slide the cable cover lock to secure the cable cover to the chassis.